Choose one of these options to proceed.
Press 1 to choose the language.
Press 2 to read the IBM terms.
Press 3 to read the non-IBM terms.
Press 4 to Proceed to accept the license terms.
The Software License Agreement acceptance menu is displayed as shown in Figure 9.38. Currently selected language: English was entered using option 4 to keep it.
1: Select language for license display.
2: Read IBM terms.
3: Read non-IBM terms.
4: Press 4 to Proceed to acceptance.
Figure 9.38: The Software License Agreement acceptance menu is displayed
Select option: 4
The text is displayed in Figure 9.38 as follows:
By choosing I agree, you agree that (1) you have had the opportunity to review the terms of both the IBM and non-IBM licenses presented above and (2) such terms govern this transaction. If you do not agree, choose I do not agree.
1: I agree
2: I do not agree
Select option: 1. We selected option 1 to continue the installation, as shown in Figure 9.39. Then we bypass the FIPS 140-2 Mode Configuration by selecting n for next screen:
Figure 9.39: The FIPS 140-2 Mode configuration is bypassed by entering n for the Next screen
We can change the virtual appliance password at this point as illustrated in Figure 9.40. If you change the virtual appliance password, continue to the next screen. We see the following prompts:
Appliance Password
Password changes are applied immediately.
Password has not been modified.
1: Change password
x: Exit
p: Previous screen
n: Next screen
On select option 1, Change password:
Change Password
Enter old password: (admin)
Enter new password: filenet
Confirm new password: filenet
Password changed successfully.
The screen is then repeated to give the option to repeat this password change:
Appliance Password
Password changes are applied immediately.
Password has been modified.
1: Change password
x: Exit
p: Previous screen
n: Next screen
We select option: n to exit from the password change loop, as shown in Figure 9.40:
Figure 9.40: Select option: n to exit from the password prompts and select 1 to update the host name
Change the host name. Use a registered host name or static IP address to manage the virtual appliance for networking and recording important information for configuring the virtual appliance network as shown in Figure 9.41:
Enter 1, Change the Host Name. Enter the new host name: (ECMUKDEMO77)
This now displays:
Host Name Configuration
Host name: ECMUKDEMO77 used
1: Change the host name
x: Exit
p: Previous screen
n: Next screen
Select option: n
Note: The hostname is cited in the SSL certificate for the virtual appliance.
Configure network interface M1 with the IP address, subnet mask, and default gateway. The next screen has the display text below, also shown in the following screenshot in Figure 9.41.
Management Interface Settings
1: Display device settings
2: Display policy
3: Configure M.1
4: Configure M.2
x: Exit
p: Previous screen
n: Next screen
Select option: 3 (Configure M.1)
Figure 9.41: The host name is entered and the IP address for networking is selected using option 3
